Hirayama HV-85 Upright Autoclave (85 Liter)
Space-saving design with lid opening upward.
Programmable auto-start for initiating a cycle up to 1 week later.
Dual-sensing lid interlock prevents lid opening when chamber is pressurized or when temperature exceeds 97°C.
Automatic air purging by a microprocessor prevents over-pressurization during a cycle.
One-touch lever to easily open and close chamber lid.
Programmable rate of steam exhaust.
Door-closure sensor provides a prompt and the cycle will not start unless the door is closed properly.
In-process display shows status and progress of sterilization cycle.
Agar sterilization modefor sterilizing agar and then automatically maintaining it at liquid temperature.
Unique accessory: Floating sensor to monitor load temperature.
Sterilization timer is activated only when load temperature reaches set temperature.
Agar melting mode for rapidly melting agar and maintaining it at liquid temperature, or for a hot and faster start-up
Memory backup system retains user-programmed parameters even in case of power failure.
105șC to 135șC
45șC to 60șC
Heating at 60șC to 100șC for up to 1 hour (temperature and time programmable), followed by 45șC to 60șC
(programmable for up to 20 hours to prevent coagulations)
3 to 30 psi (0.021 to 0.206MPa)
38 psi ( 0.26MPa)
1 to 250 minutes
Program autoclave to start 1 minute to 7 days later
|Overall (W x D x H)||
26.0" x 25.6" x 39.4"
(66 cm x 65 cm x 100 cm)
(Diameter x Height)
16.5" x 24.2" (42.0 cm x 61.5 cm)
Dual-sensing lid interlock, over-pressure power cutoff, over-temperature power cutoff, low-water power cutoff, mechanical pressure relief valve, microprocessor-controlled pressure relief valve, lid-closure detector, over-current detector and circuit breaker
|1. For agar||
Heating -> Sterilization -> Exhaust (from no exhaust to slow, programmable) -> Warming -> Completion
|2. For liquids||
Heating -> Sterilization -> Exhaust (from no exhaust to slow, programmable) -> Completion
|3. For solids||
Heating -> Sterilization -> Exhaust (fast, default) -> Completion
|4. For melting agar or for faster start-up||
Rapid melting at 60°C to 100°C (temperature and time programmable) -> Maintain at 45°C to 60°C (temperature programmable) -> Completion
Mesh wire baskets, buckets (pails), and round test tube rack
|Factory or field installed||
Floating (load) sensor, digital printer, and data logger
208V/220V/240V, 50/60 Hz, single phase
3000 watts (3000VA)
282 lb (128 kg)
WARRANTY: Autoclaves are protected by a 12-month warranty.